Assignment 16                                                                        9.5.2018

Topic: Machine design

• Actuate and automate your machine (Group) (LINK)
  
• Document the group project and your individual contribution (Group) (LINK)

What I did this week

• Lasercut and attached boxes for the motor

I used boxes py to create 3 boxes: 1 for motor and 2 for surface. Boxes were super precise so they attached well together when I hammered
pieces together. I also lasercut mdf surface top of the cardboard surface to limit bending. I used wood glue and sticker pads to attach
these pieces together. Finally, everything was attached to the cardboard surface:







• Connected clutch with the motor
To connect the clutch with the motor, I used wool to stuck the motor inside and screws to hold it there. The end result was fine:





• Designed, cut and assembled peeler holder

Our plastic container had already 3.5mm diameter holes between 19mm engraved to it, so I created corresponding hole-pattern
in Fusion 360. In total, it took me few tries to get kerf and the sizes correct, but in a end I came up with good design:



I screwed the peeler holder to plastic part with bolts. The connection was durable:

FILES made THIS WEEK

• Peeler stick pdf. file
  
• Box1 pdf. file
  
• Box2 and Box 3 pdf. file