/*
 * /*
  Blink

  Turns an LED on for one second, then off for one second, repeatedly.

  Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZERO
  it is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN is set to
  the correct LED pin independent of which board is used.
  If you want to know what pin the on-board LED is connected to on your Arduino
  model, check the Technical Specs of your board at:
  https://www.arduino.cc/en/Main/Products

  modified 8 May 2014
  by Scott Fitzgerald
  modified 2 Sep 2016
  by Arturo Guadalupi
  modified 8 Sep 2016
  by Colby Newman

  This example code is in the public domain.

  http://www.arduino.cc/en/Tutorial/Blink

 * blink IR LED then LED
 * Mofified by Eidha alrashdi for fab academy 2018
 * 2/5/2018
 * 
*/

void setup() {

  pinMode(7, OUTPUT);
  pinMode(5, OUTPUT);
}

void loop() {
  digitalWrite(7, HIGH); 
   delay(1000);
     digitalWrite(7, LOW);
   delay(1000);  
   digitalWrite(5, HIGH);
  delay(1000);                  
 
   digitalWrite(5, LOW);    
  delay(1000);                    
}